Tatra T815-7 8x8 by Hanys
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
Beadlock disk Michelin
There are some photos of my beadlock disks.
It's drilled under templates burned by CNC laser. Mothers are M2 overdrill to 2,5mm and maded thread M3.
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
Disks are mounted on shaft 6mm diameter.igor1300 pisze:AWSOME dude...
it's mounted on pin, hex or something else?
On end of shaft is M6 thread, disk is screw on shaft and then is fixed by 1 piece of covering headless screws.
Ostatnio zmieniony 2009-09-09, 19:47 przez Hanys, łącznie zmieniany 1 raz.
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
T815-7 test of servo and turning bars tatravize 3000
T815-7 test of servo and turning bars tatravize 3000:
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
Thanx.rudi pisze:Really nice job.
The screws on whells are 3mm or smaller?
You have one gear more on the turning bars?
Screws are M3 and female screw are M2 overdrill to M3.
Yes, I have gear more on the turning bars. There is a Hitec 805 servo modified elekronicaly so that it spins around and around with the possibility to change the rotational speed of the size of the current deflection of the lever at the transmitter. When I let the lever servo stops at the position where now is not coming back to position 0. I hope that an additional transfer (3:1) gives turning mechanism greater power